Step 1 Connect the RJ-45-to-DB-9 adapter cable to the 9-pin serial port on the PC. The RJ-45 console port is on the rear panel of the switch. Use one of these options to access the CLI: You can perform the initial configuration for the entire stack on any switch in the stack. Note If you have stacked Catalyst 3650 switches, connect to the 10/100/1000 Ethernet management port or console port of one of the stack switches. You can enter Cisco IOS commands and parameters through the CLI. Accessing the CL I Through a Console Port However, you lose the Telnet connection after entering the write memory command.įor more information about using the CLI, see the Cisco Catalyst 3650 Series Switches Command Reference Guides at. Note While in Express Setup mode, the IP address 10.0.0.1 remains active on the switch until you enter the write memory command. Īfter you have entered the configuration information for the switch, save it to flash memory by using the write memory privileged EXEC command. Enter the information described in the “Entering the Initial Configuration Information” section. When the switch is in Express Setup mode, open a Telnet session to the switch by entering the IP address 10.0.0.1. To put the switch into Express Setup mode, follow the steps described in the Catalyst 3650 Switch Getting Started Guide at. You can access the CLI on an unconfigured switch by placing the switch in Express Setup mode and then connecting a switch Ethernet port or the Ethernet management port to the Ethernet port of your PC or workstation. The following are the various ways in which the CLI can be accessed. Entering the Initial Configuration Information.This chapter includes the following topics: Before connecting the switch to a power source, review the safety warnings thoroughly. To set up the switch by using Express Setup, see the Catalyst 3650 Switch Getting Started Guide.

This appendix provides a CLI-based setup procedure for a Catalyst 3650 standalone switch or a switch stack.

Configuring the Switch with the CLI-Based Setup Program

Cisco usb console driver